FREQUENTLY ASKED QUESTIONS on our Frozen Cocktail & Granita Slush Machines
REPAIRS & SERVICE:
Need a Slush Machine Repaired or Serviced in Your Area?
Whilst we are wholesalers and do not employ technicians Australia wide -
we do have a large contact base of reputable service people who can carry out repairs on Your Slush Machine
Please see below to Check if one is listed in Your area or search for
"Slush Machine Repairs" OR "Refrigeration Mechanic" in Your State or Suburb.
The following list of Slush Machine Repairers & Refrigeration Mechanics are not employed or contractually
endorsed by ASM & are merely provided for your assistance
If PARTS are required for ASM SEA&C JetIce units please contact us directly.
BEFORE calling a technician to look at your slush machine always ensure you have READ
your INSTRUCTIONS correctly & completely....
Easy Fix Slush Machine Troubleshooting
Spiral Auger Stopping / Unit Not Freezing: Reset Sensors
Q1. Is the problem limited to ONE side of the unit or BOTH sides of the unit?
Q2. Have you followed all steps to reset sensors, unplugged machine and slowly turned switched on one by one ensuring
the augers are turning on both sides and the unit os set to Freeze mode (switches UP)
on both sides and mix at correct ratio on BOTH sides?
If it's stopping it usually means too much water in the mix which will cause it to freeze over and stop gears so as not to blow up the motor
Ensure you have enough syrup in mix and if any condensation adds to water you need to add syrup and reduce setting at rear to much less Icey
This part is essential if it is not freezing: Turn off unit at power then turn off all switches and reset thermostat
by turning on again after 1 minute;
slowly turning switches back on one by one after reducing setting at rear to much lower number (near “1”)…
.It is imperative you follow these steps exactly to RESET the thermostat sensors if the unit is not freezing up...
Unit may be on or near minimum or maximum freeze which may be too high
or low in winter or too high if no alcohol has been added
Also ensure you've lubricated all the seals
Augers / spirals can also catch if unit not lubed adequately. You may need to remove bowls and augers then lube then restart
with correctly measured mix
Never use poor grade or weak mix and always use approved slush syrup or damage may result
If the above steps have all been followed and sensors have been reset and mix is correct, then you may want to get a
refrigeration mechanic to check your unit for a service:
NSW, Sydney & Central Coast - NSW - zeusrefrigeration.com.au 0404 270 102
S.A.- Adelaide - prssa.com.au 0437151319
S.A.- Virginia - Peter - 0418829253
Tullamarine, Victoria - Brett - 0414856222
Mentone, Victoria - Mark - 0407211695
Mordialloc, Victoria - - Mornington Refrigeration - 0418383775
Bon Beach, Victoria - 03 87747767
Somerville, Victoria - Coldvend - 0417544502
Upper Ferntree Gully, Victoria - Chatfield Ozcool - 0408523099
NSW, Bathurst - Fridgcon - 0418639027
NSW, Culburra - 0429061370
Victoria, Mildura - 0408857756
Victoria, Pakenham - Cool Solutions - 0413542472
QLD, Brisbane - Richard - 0411981801
NSW, Gosford - CBS Slush Repairs - 0405505568
NSW, Coffs Harbour - Faircloth & Reynolds - 0266917200 - FairclothReynolds.com.au
NSW, Dave's Refrigeration Sydney - 0404858040
NSW, Weston Refrigeration NSW - 0448730744 - Warren
NSW, Newcastle - Daryl - 0401691414
QLD, Central Commercial Electrics - Rockhampton QLD - 0749271205 or (AH) 0407954790
QLD, All So Cool - Mansfield QLD (near Brisbane) - allsocool.com.au - 0418719604
QLD, Brett Bolton Electrical - Weipa QLD - 0429991341
N.T.- Dymanic Refrigeration Solutions - Winnellie NT - 1300112187
W.A.- Kalbarri Refrigeration - 0429202313
NSW, Deniliquin - ID Appliance Service - 0417629488
NSW, Forster & Taree Regions - R&L Refrigeration - 0427206099
NSW, Griffith Catering & Repairs - 02 69645000
Victoria, Kyabram - Arctic Refrigeration - 0409531172
Victoria, Wodonga - M&H Plumbing & Refrigeration - 0409811770
QLD, Longreach - Saunders Electrics - 07 46581001
QLD, Woree - Jackson & Jackson Refrigeration - 07 40346000
QLD, Underwood - Refrigeration House of QLD - 0422336012 or 07 38086000
Why is it when I pull the handle down no ice comes out, only liquid, even though the slush machine is frozen?
If this situation happens it means that a piece of ice that is bigger then the hole were the slushie exits from has blocked this hole.
This occasionally happens when a piece of ice misses being broken up by the moving spiral.
All you need to do is pull down on the handle of the slushie machine. This will lift the white tube attached to the handle exposing the slushie exit hole.
If you get a straw and poke it up the handle column and then push it across horizontally into the slushie machine,
you will be able to push that ice cube back into the machine which will then be broken up by
the moving spiral and the slush will then come out freely.
Why is only one side of my slush machine frozen?
In 99% of cases, this is nothing to worry about as it is just the way the slush machine freezing process works.
The slush machine will start freezing the left bowl first,
then move to the to the right bowl. If after 2 hours one side is still not frozen, then it may be a solenoid problem.
If this is the case, contact a service technician in your area & contact us for spare parts.
Why is the tap dripping?
In rare instances the taps may get a slight drip. In most cases, as the slush machine freezes up the dripping will stop.
Just keep a jug underneath the slush machine and you can pour the slush mix back in when it is frozen.
If it doesn’t stop, your handle seal may need to be changed or lubricated with Lubrifilm.
Please follow instructions & ensure you lubricate the seals regularly.
Why is the machine not freezing?
In most cases, there is an issue with the environment surrounding the slush machine, not the slush machine itself.
Make sure there is at least 30 cm’s of space at the back of the slush machine and on either side of the machine so the slush machine
can draw in fresh air and expel hot air.
Make sure your slush machine is not sitting in direct sunlight or in an area were there is a lot of heat like next to an oven or barbecue.
Make sure the slush machine is turned on and that the switches have not been switched to defrost mode.
Make sure the slush machine is powered on and that the power supply is not cutting out.
The slush machine must be connected to a power point directly and not to a power board,
and must not have other appliances connected to the same power point as the slush machine draws a lot of power.
See notes below also on Generator power.
If you don’t see any ice in your slush machine after 2 hours, please call a technician in your area to service your slush machine.
Why is my slush machine making a clicking noise?
Some of the time a slush machine will make a clicking noise. This is nothing to worry about as it is just the slush machine
adjusting the torque tension inside the machine to ensure it produces the correct slush ice consistency.
What's the difference between a Slush, Slushy, Slurpee, Frozen Cocktail & Granita Drink Machine?
Granita or Frozen Cocktail or Slushee / Slush Machines are known by many names & are the same machine.
These are simply different names used to refer to a frozen drink machine unit.
The units make Slushies, Cocktails or Granita Drinks.
They are frozen icey drinks with flavour and can contain Slush Machine Syrup or Juice and can be made with or without alcohol.
How Do I Order Mix or Slush Machines?
Download, Scan & Return our Credit Card Payment Order Form Here or Call to Order on 0447587446
Are your Slush Machines easy to use & clean?
Yes, our state of the art machines are extremely easy to use. They arrive ready assembled.
We email easy to follow instructions on the operation of the machine but if you can turn on a
power point and pour in 1 bottle of concentrate then you are already an expert!
View Our Instructional Video On How To Clean Your Slush Unit:
How long does it take for the mix to freeze in the cocktail slushee machines?
It takes about 45 minutes for the first batch to freeze in normal conditions.
We recommend you turn the unit on at least 90-120 minutes
prior to your function start time, let it freeze then
turn off the unit and add 1 bottle of alcohol per side. You add the alcohol
(it is economical and you know what is in the drinks - real alcohol not toxic chemical essence!!)
Do I need to provide any ice or freeze the bottles of slush drink / granita mix?
No. No ice is needed, the machine freezes the mix and creates the ice for you!
What do I need to supply for the frozen slushees & cocktails?
All you need to supply is Strong Table or bench* - No plastic or glass top, a standard 10 Amp power point,
alcohol (1 bottle per side) and friends to drink your amazing frozen
cocktail or slushee drinks.
Do you have bigger slushy machines? Yes. We have 1, 2, 3 or massive 4 bowl cocktail machines available on request!
How do I order a Slush Machine to Buy in Australia?
Simply call or email us.
What payment methods do Australian Slush Machines accept?
· Cheque: (send to: Jet Ice Slush, P.O. Box 817, Mt Eliza VIC 3930).
· Bank deposit (Westpac Bank: BSB: 033 131 AC: 262 204 Name: Jet Ice Slush).
· Credit Card: Call 0447587446 to pay by credit card
We will also issue a Tax Invoice that can be paid by Credit Card Online.
Via Paypal Login & Join at www.paypal.com.au and use firstname.lastname@example.org as payee.
Is there a delivery charge for a Slushee Machine?
We deliver Australia wide via StarTrack Express
and have very competitive rates including insurance to your door.
What alcohol do I need to supply? Please click on our Cocktail Recipes for full details, It's easy!
A note on Generators & Slush Machines and Ice Cream Machines
NB: Ice Cream Machines & Slush Machines Require Quality Uninterrupted 240v Power
If you are running machines on a generator you need to fully ensure the generator is adequate.
It must be up to the task taking into account other appliances running off the same generator.
Generator power is not recommended as the preferred power for any slush or ice cream unit as these units contain a PCB board and regulators for freezing mechanisms
An inadequate power supply can not only alter the calibration but can cause permanent damage!
Please do your research when sourcing any generator!
Do not cut corners as the wrong generator will cause more problems than it is worth.
It may not perform properly & may cause damage not covered under warranty.
Need more information on our Quality Slush Machines?
If you have any further questions or suggestions please don’t hesitate to call
or text SMS us on 0447587446 or email: Sales@AustralianSlushMachines.com.au